## In order to understand the A-a gradient we need to first understand what affects the pressure of oxygen at four points in the respiratory system.

#### Artery

As soon as this oxygen is inhaled it will lose pressure.

This is because there as water vapour which also exerts a pressure in the airways.

So now we have atmospheric pressure at sea level minus water vapor pressure multiplied by the percentage of oxygen.

### So the pressure of oxygen in the airway is now 150mmHg

So now to work out the pressure in the avleoli we need to take all the above into account.

We need to now subtract the partial pressure of CO2 (40mmHg) divided by the respiratory quotient.

### So the pressure of oxygen in the alveoli or the PAO2 is 100mmhg.

Note the capital A here.

To work out the pressure of oxygen in our atmosphere take the barometric pressure (760mmHg) at sea level, and multiply that by the concentration of oxygen in the atmosphere which is 21% (0.21).

## So the PO2 in the atmosphere is 160mmHg.

The levels in the alveoli are further influenced by two other factors.

These are both related to the presence of CO2

This is leaving the body as the O2 is entering and the relationship between the two is known as the respiratory quotient.

### The respiratory quotient is 0.8

The pressure of CO2 in the alveoli is approximately 40mmHg

# Artery

If there is no lung disease then the pressure of oxygen within the artery should also be 100mmHg.

### So the PaO2 should be 100mmHg

Note the small 'a' here.

# When calculating the gradient it is necessary to take into account the percentage of oxygen.

### The content on the website is provided for FREE as is the podcast.

You could help support this work by going to Amazon via this link. This means that I will earn a small commission from any purchases you make with NO extra cost to yourself.

Thank you.

Tagged with →
Share →

### 5 Responses to Mechanical Ventilation Series- A-a gradient.

1. Good stuff. This is sure to help at least a few pre-med students somewhere 🙂

• Jonathan Downham says:

2. elhoseny says:

how would you calculate the A – a gradient in a mechanically ventilated patient where the pressure is above the atmospheric pressure and the water vapour would be different bec of the humidifier effect ?

• Jonathan Downham says:

Good question. Atmospheric pressure does not vary greatly for most of us. The pressure used to get the gas into the patient is not what is put into the A-a gradient formula. And to quote Oxygenation and oxygen therapy

Water vapor pressure in the airways is dependent only on body temperature and is 47 mm Hg at normal body temperature (37 degrees C).

3. stavros says:

Thank you for explaining!How can we apply the formula PAO2=FIO2-PCO2/0.8 when we have mechanical ventilation 100%? Doew FIO2 changes?